Feature Request P3
Status Update
No update yet.
Comments
be...@google.com
Really I've waited more than 4 minutes to attach to the process, and it didn't finish.
Even trying to cancel it using the button failed, and I had to kill the process of the IDE
Even trying to cancel it using the button failed, and I had to kill the process of the IDE
br...@google.com
Attached logs of the IDE after I started it , after killing it.
Otherwise I can't do it because it's an annoying dialog that doesn't let me do anything except looking at it being stuck.
Otherwise I can't do it because it's an annoying dialog that doesn't let me do anything except looking at it being stuck.
no...@google.com
Attached screenshot. This occurs also when pressing the debug button...
Description
zmarcus@ found a kefka in pool:wificell that was showing SISO rates in `iw wlan0 station dump` on both AP (managed0) and DUT (wlan0) sides while running VHT80 perf tests.
Signal levels showed -14 and -60, IIRC, indicating one connector was broken.
This was detected in software and a physical check showed that one pigtail was indeed not connected.
I think this is a useful check to have on the DUT side as well - ronaldho@
sent
one of his antenna on the Fizz is not connected properly.
Here's the station dump from his feedback report:
Note the rx at 1Mbps (basic rate) and wildly different signal on each antenna.
w dev wlan0 station dump:
Station f4:f2:6d:##:##:## (on wlan0)
inactive time: 97 ms
rx bytes: 63851271
rx packets: 37947
tx bytes: 7915853
tx packets: 29070
tx retries: 2502
tx failed: 20
beacon loss: 0
rx drop misc: 889
signal: -12 [-12, -51] dBm
signal avg: -13 [-13, -43] dBm
tx bitrate: 130.0 MBit/s MCS 14 short GI
rx bitrate: 1.0 MBit/s
authorized: yes
authenticated: yes
associated: yes
preamble: long
WMM/WME: yes
MFP: no